Copper monosulfide

Copper monosulfide
Names

IUPAC name Copper sulfide
Other names Covellite Copper(II) sulfide Cupric sulfide
Identifiers
CAS Number	1317-40-4^Y
3D model (JSmol)	Interactive image
ChemSpider	14145^Y
ECHA InfoCard	100.013.884
EC Number	215-271-2
PubChem CID	14831
RTECS number	GL8912000
UNII	KL4YU612X7^Y
CompTox Dashboard (EPA)	DTXSID601316949 DTXSID0061666, DTXSID601316949
InChI InChI=1S/Cu.S^Y Key: BWFPGXWASODCHM-UHFFFAOYSA-N^Y InChI=1/Cu.S/rCuS/c1-2 Key: BWFPGXWASODCHM-BLKBWTQCAT
SMILES [Cu]=S
Properties
Chemical formula	CuS
Molar mass	95.611 g/mol
Appearance	black powder or lumps
Density	4.76 g/cm³
Melting point	above 500 °C (932 °F; 773 K) (decomposes)^[2]
Solubility in water	0.000033 g/100 ml (18 °C)
Solubility product (K_sp)	6 x 10⁻³⁷^[1]
Solubility	soluble in HNO₃, NH₄OH, KCN insoluble in HCl, H₂SO₄
Magnetic susceptibility (χ)	-2.0·10⁻⁶ cm³/mol
Refractive index (n_D)	1.45
Structure
Crystal structure	hexagonal
Hazards
GHS labelling:
Pictograms
Hazard statements	H413
Precautionary statements	P273, P501
NIOSH (US health exposure limits):
PEL (Permissible)	TWA 1 mg/m³ (as Cu)^[3]
REL (Recommended)	TWA 1 mg/m³ (as Cu)^[3]
IDLH (Immediate danger)	TWA 100 mg/m³ (as Cu)^[3]
Related compounds
Other anions	Copper(II) oxide
Other cations	zinc sulfide
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa). Y verify (what is ^YN ?) Infobox references

Chemical compound

Copper monosulfide is a chemical compound of copper and sulfur. It was initially thought to occur in nature as the dark indigo blue mineral covellite. However, it was later shown to be rather a cuprous compound, formula Cu⁺₃S(S₂).^[4] CuS is a moderate conductor of electricity.^[5] A black colloidal precipitate of CuS is formed when hydrogen sulfide, H₂S, is bubbled through solutions of Cu(II) salts.^[6] It is one of a number of binary compounds of copper and sulfur (see copper sulfide for an overview of this subject), and has attracted interest because of its potential uses in catalysis^[7] and photovoltaics.^[8]

Manufacturing

Copper monosulfide can be prepared by passing hydrogen sulfide gas into a solution of copper(II) salt.

Alternatively, it can be prepared by melting an excess of sulfur with copper(I) sulfide or by precipitation with hydrogen sulfide from a solution of anhydrous copper(II) chloride in anhydrous ethanol.

The reaction of copper with molten sulfur followed by boiling sodium hydroxide and the reaction of sodium sulfide with aqueous copper sulfate will also produce copper sulfide.

CuS structure and bonding

Copper sulfide crystallizes in the hexagonal crystal system, and this is the form of the mineral covellite. There is also an amorphous high pressure form^[9] which on the basis of the Raman spectrum has been described as having a distorted covellite structure. An amorphous room temperature semiconducting form produced by the reaction of a Cu(II) ethylenediamine complex with thiourea has been reported, which transforms to the crystalline covellite form at 30 °C.^[10]
The crystal structure of covellite has been reported several times,^[11]^[12]^[13] and whilst these studies are in general agreement on assigning the space group P6₃/mmc there are small discrepancies in bond lengths and angles between them. The structure was described as "extraordinary" by Wells^[14] and is quite different from copper(II) oxide, but similar to CuSe (klockmannite). The covellite unit cell contains 6 formula units (12 atoms) in which:

4 Cu atoms have tetrahedral coordination (see illustration).
2 Cu atoms have trigonal planar coordination (see illustration).
2 pairs of S atoms are only 207.1 pm apart^[13] indicating the existence of an S-S bond (a disulfide unit).
the 2 remaining S atoms form trigonal planar triangles around the copper atoms, and are surrounded by five Cu atoms in a pentagonal bipyramid (see illustration).
The S atoms at each end of a disulfide unit are tetrahedrally coordinated to 3 tetrahedrally coordinated Cu atoms and the other S atom in the disulfide unit (see illustration).

The formulation of copper sulfide as Cu^IIS (i.e. containing no sulfur-sulfur bond) is clearly incompatible with the crystal structure, and also at variance with the observed diamagnetism^[15] as a Cu(II) compound would have a d⁹ configuration and be expected to be paramagnetic.^[6]
Studies using XPS^[16]^[17]^[18]^[19] indicate that all of the copper atoms have an oxidation state of +1. This contradicts a formulation based on the crystal structure and obeying the octet rule that is found in many textbooks (e.g.^[6]^[20]) describing CuS as containing both Cu^I and Cu^II i.e. (Cu⁺)₂Cu²⁺(S₂)²⁻S²⁻. An alternative formulation as (Cu⁺)₃(S²⁻)(S₂)⁻ was proposed and supported by calculations.^[21] The formulation should not be interpreted as containing radical anion, but rather that there is a delocalized valence "hole".^[21]^[22] Electron paramagnetic resonance studies on the precipitation of Cu(II) salts indicates that the reduction of Cu(II) to Cu(I) occurs in solution.^[23]


ball-and-stick model of part of the crystal structure of covellite	trigonal planar coordination of copper	tetrahedral coordination of copper	trigonal bipyramidal coordination of sulfur	tetrahedral coordination of sulfur-note disulfide unit

References

^ Rollie J. Myers (1986). "The new low value for the second dissociation constant for H2S: Its history, its best value, and its impact on the teaching of sulfide equilibria". J. Chem. Educ. 63 (8): 687. Bibcode:1986JChEd..63..687M. doi:10.1021/ed063p687.
^ Blachnik, R.; Müller, A. (2000). "The formation of Cu₂S from the elements I. Copper used in form of powders". Thermochimica Acta. 361 (1–2): 31–52. doi:10.1016/S0040-6031(00)00545-1.
^ ^a ^b ^c NIOSH Pocket Guide to Chemical Hazards. "#0150". National Institute for Occupational Safety and Health (NIOSH).
^ Liang, W., Whangbo, M.H. (1993) Conductivity anisotropy and structural phase transition in Covellite CuS Solid State Communications, 85(5), 405-408
^ Wells A.F. (1962) Structural Inorganic Chemistry 3d edition Oxford University Press
^ ^a ^b ^c Greenwood, Norman N.; Earnshaw, Alan (1997). Chemistry of the Elements (2nd ed.). Butterworth-Heinemann. ISBN 978-0-08-037941-8.
^ Kuchmii, S.Y.; Korzhak A.V.; Raevskaya A.E.; Kryukov A.I. (2001). "Catalysis of the Sodium Sulfide Reduction of Methylviologene by CuS Nanoparticles". Theoretical and Experimental Chemistry. 37 (1). New York: Springer: 36–41. doi:10.1023/A:1010465823376. S2CID 91893521.
^ Mane, R.S.; Lokhande C.D. (June 2000). "Chemical deposition method for metal chalcogenide thin films". Materials Chemistry and Physics. 65 (1): 1–31. doi:10.1016/S0254-0584(00)00217-0.
^ Peiris, M; Sweeney, J.S.; Campbell, A.J.; Heinz D. L. (1996). "Pressure-induced amorphization of covellite, CuS". J. Chem. Phys. 104 (1): 11–16. Bibcode:1996JChPh.104...11P. doi:10.1063/1.470870.
^ Grijalva, H.; Inoue, M.; Boggavarapu, S.; Calvert, P. (1996). "Amorphous and crystalline copper sulfides, CuS". J. Mater. Chem. 6 (7): 1157–1160. doi:10.1039/JM9960601157.
^ Oftedal, I. (1932). "Die Kristallstruktur des Covellins (CuS)". Z. Kristallogr. 83 (1–6): 9–25. doi:10.1524/zkri.1932.83.1.9. S2CID 101164006.
^ Berry, L. G. (1954). "The crystal structure of covellite CuS and klockmannite CuSe". American Mineralogist. 39: 504.
^ ^a ^b Evans, H.T. Jr.; Konnert J. (1976). "Crystal structure refinement of covellite". American Mineralogist. 61: 996–1000.
^ Wells A.F. (1984) Structural Inorganic Chemistry 5th edition Oxford Science Publications ISBN 0-19-855370-6
^ Magnetic susceptibility of the elements and inorganic compounds Archived 2012-01-12 at the Wayback Machine
^ Nakai, I.; Sugitani, Y.; Nagashima, K.; Niwa, Y. (1978). "X-ray photoelectron spectroscopic study of copper minerals". Journal of Inorganic and Nuclear Chemistry. 40 (5): 789–791. doi:10.1016/0022-1902(78)80152-3.
^ Folmer, J.C.W.; Jellinek F. (1980). "The valence of copper in sulfides and selenides: An X-ray photoelectron spectroscopy study". Journal of the Less Common Metals. 76 (1–2): 789–791. doi:10.1016/0022-5088(80)90019-3.
^ Folmer, J.C.W.; Jellinek F.; Calis G.H.M (1988). "The electronic structure of pyrites, particularly CuS₂ and Fe_1−xCu_xSe_{_₂}: An XPS and Mössbauer study". Journal of Solid State Chemistry. 72 (1): 137–144. Bibcode:1988JSSCh..72..137F. doi:10.1016/0022-4596(88)90017-5.
^ Goh, S.W.; Buckley A.N.; Lamb R.N. (February 2006). "Copper(II) sulfide?". Minerals Engineering. 19 (2): 204–208. doi:10.1016/j.mineng.2005.09.003.
^ Cotton, F. Albert; Wilkinson, Geoffrey; Murillo, Carlos A.; Bochmann, Manfred (1999), Advanced Inorganic Chemistry (6th ed.), New York: Wiley-Interscience, ISBN 0-471-19957-5
^ ^a ^b Liang, W.; Whangbo M, -H (February 1993). "Conductivity anisotropy and structural phase transition in Covellite CuS". Solid State Communications. 85 (5): 405–408. Bibcode:1993SSCom..85..405L. doi:10.1016/0038-1098(93)90689-K.
^ Nozaki, H; Shibata, K; Ohhashi,N. (April 1991). "Metallic hole conduction in CuS". Journal of Solid State Chemistry. 91 (2): 306–311. Bibcode:1991JSSCh..91..306N. doi:10.1016/0022-4596(91)90085-V.
^ Luther, GW; Theberge SM; Rozan TF; Rickard D; Rowlands CC; Oldroyd A. (February 2002). "Aqueous copper sulfide clusters as intermediates during copper sulfide formation". Environ. Sci. Technol. 36 (3): 394–402. Bibcode:2002EnST...36..394L. doi:10.1021/es010906k. PMID 11871554.